Installation Guide

Follow these steps to install your Syurelife lighting safely and correctly the first time.

Safety First

Turn off power at the circuit breaker before any electrical work.
Read the instruction manual included with your product before starting.
Use only UL-listed power supplies and connectors.
Keep lights away from water and heat sources unless the product is specifically rated for them.
Do not install while the lights are connected to power.

Plan your layout. Measure the area and mark where each light or strip will go. Dry-fit before mounting.
Prepare the surface. Clean and fully dry the mounting surface so adhesives and clips hold firmly.
Mount the lights. Attach clips or peel-and-stick backing, pressing firmly for 10 seconds.
Connect power. Plug into the included adapter, keeping connections away from moisture.
Test everything. Power on and confirm every section lights up before tidying cables.

For LED strips, cut only at the marked cut lines.
Avoid sharp bends that can damage the circuit.
For outdoor installs, seal connections with heat-shrink tubing or waterproof tape.

Watch our video guides or contact Product Support if you get stuck.